Price: 1750 EUR excluding shipping.
The topology is fully balanced, open loop (no gNFB) amp with parafeed transformer output. The input stage is single ended, followed by CCS loaded source followers that drive the output tube grids. The grid drivers relieve the input tube of any drive duty. Tubes do only voltage amplification. Tubes do what they do best and FETs do what they do best, supply current.
The LTP output stage is perfectly balanced by using a very powerful CCS in the tail. All tube anodes are gyrator loaded. Both B+ and B- supplies are regulated.
This amp can drive most headphones from very low impedance up to high impedance with ease. It’s also capable of driving speakers.
The speaker outputs are also balanced, meaning the black terminal is not ground but is carrying signal in anti-phase to the red terminal. This is a great way to drive a speaker coil.
More pictures and info on the amps page
Height: 225mm including spikes and tubes.
Depth: 350mm incl. knobs and speaker outputs.
Width: 435mm, faceplate is 450mm
2 x 6AT6 for input stage (or 6AV6 with speaker outputs)
4 x EL81 for output stage
Single ended 2 x RCA
Balanced 4-pin XLR
2,7W into 4 ohms, 2W into 8ohms, 800mW into 20 ohms, 500mW into 32 ohms, 200mW into 100 ohms, 83mW into 200 ohms, 65mW into 300 ohms.
With optional impedance switch:
Low: 2,7W into 4 ohms, 2W into 8 ohms, 800mW into 20 ohms, 500mW into 32 ohms, 200mW into 100 ohms, 83mW into 200 ohms, 65mW into 300 ohms.
High: 2,3W into 20 ohms, 1,5W into 32 ohms, 425mW into 100 ohms, 275mW into 200 ohms, 165mW into 300 ohms.
Speaker outputs with selector switch: 175 EUR
Line level RCA outputs (for active subwoofer): 60 EUR
Low/high impedance switch: 120 EUR
Pre-amp outputs (3-pin XLR) with selector switch: 175 EUR
XLR inputs (for convenience): 65 EUR
SE ¼” headphone jack with switch: 130 EUR
Please visit the contact page to order or ask any questions.